Neue IH602FL Uživatelský manuál stáhnout pdf (Strana 12)

Problem Possible cause Remedy

The cookware is unsuitable. Use suitable cookware. Refer to

"Hints and tips".

The diameter of the bottom of the

cookware is too small for the zone.

Use cookware with correct dimen-

sions. Refer to "Technical data".

and a number come on.

There is an error in the hob. Deactivate the hob and activate it

again after 30 seconds. If

comes on again, disconnect the hob

from the electrical supply. After 30

seconds, connect the hob again. If

the problem continues, speak to an

Authorised Service Centre.

You can hear a constant beep

noise.

The electrical connection is incor-

rect.

Disconnect the hob from the electri-

cal supply. Ask a qualified electri-

cian to check the installation.

If you cannot find a solution...

If you cannot find a solution to the problem yourself,

contact your dealer or an Authorised Service Centre.

Give the data from the rating plate. Give also three digit

letter code for the glass ceramic (it is in the corner of the

glass surface) and an error message that comes on.

Make sure, you operated the hob correctly. If not the

servicing by a service technician or dealer will not be

free of charge, also during the warranty period. The

instructions about the Service Centre and conditions of

guarantee are in the guarantee booklet.

Installation

Warning! Refer to Safety chapters.

Before the installation

Before you install the hob, write down the information

bellow from the rating plate. The rating plate is on the

bottom of the hob.

Serial number ...........................

Built-in hobs

Only use the built-in hobs after you assemble the hob

into correct built-in units and work surfaces that align to

the standards.

Connection cable

• For a single phase or two phase connection, use the

cable type: H05BB-F or H03V2V2-F which

withstands a temperature of 70°C or higher.

• To replace the damaged mains cable, use the cable:

H05BB-F or H03V2V2-F which withstands a

temperature of 70°C or higher.

Assembly

min.

50mm

min.

500mm

1 2 ... 7 8 9 10 11 12 13 14 15 16

Komentáře k této Příručce

Žádné komentáře

Neue IH602FL Uživatelský manuál Strana 12

Komentáře k této Příručce